The reality for many of the local venues is seaweed. In such circumstances it’s essential to have a fin that sheds weed, yet still lets you unleash the potential of the flat water and wind available. With straight leading edge weed fins, the rake has to be set for the span-wise flow to pull seaweed along the leading edge to the tip. This causes the lifting surface in the tip to be located a long way behind the centre of rotation of the board (trim axis). This is not really a problem deep off the wind with short speed fins, but as you go larger the problem becomes worse. In the end, the straight leading edge is a big compromise in balance. Upwind or across the wind, where the centre of pressure of the fin is too far back for optimal balance with the rig, is where you notice this the most.
CONVENTIONAL WEED FIN DESIGNS
TYPES OF SEAWEED
There are many types of seaweed, and the ability of a fin to successfully shed these different types of weed very much depends on the fin design, as well as local variables. Some weed is heavier and more abrasive, and requires a greater angle for successful shedding.
WEEDSPEED VS SUPERWEED
Besides our regular WeedSpeed fins, we have added the SuperWeed to our range for special use in those areas where extreme “sticky” weed growth occurs and our regular Weed fin does not quite cut it anymore … The SuperWeed’s rake is set up at a more extreme angle than the WeedSpeed to shed weed. It does have a straighter leading edge due to the need to keep the centre of pressure as far forward as possible, whilst maintaining an increased minimum rake angle at the head.
SIZE CHART
| SIZE | SAIL SIZE | 10 | 9 | 8 | 7 | 6 | 5 | 4 |
|---|---|---|---|---|---|---|---|---|
| WIDTH | VOLUME | |||||||
| 80-90 | 125+ | 43 | 43 | 41 | ||||
| 75-80 | 120-125 | 41 | 39 | 37 | ||||
| 70-75 | 115-120 | 37 | 37 | 35 | 33 | |||
| 65-70 | 110-115 | 35 | 33 | 31 | ||||
| 60-65 | 100-110 | 33 | 31 | 29 | ||||
| 55-60 | 90-100 | 29 | 29 | 27 | ||||
| 45-55 | 75-90 | 27 | 25 | 23 | 23 | |||
| 40-50 | 50-75 | 23 | 21 | 19 |
The reality for many of the local venues is seaweed. In such circumstances it’s essential to have a fin that sheds weed, yet still lets you unleash the potential of the flat water and wind available!
Chris Lockwood
designer
RANGE OF USE
DOWNWIND SLALOM
100%
FIGURE 8
100%
GPS SPEED
96%
CHOPPY WATER
100%
OPEN OCEAN
96%
QUESTIONS? GET IN CONTACT
FAQ
My fin doesn't fit in my board...
In practice, we see many boards with different boxes, so it’s always hard to get the perfect fit for all boards. Please do not be afraid to sand the box down a bit to get the perfect fit for your board. Also be aware, that if a fin sinks a bit into the box, it is not an issue. However, a fin that sticks out above the box is an issue and needs sanding down. If you do not feel comfortable with the fit, please do not hesitate to contact us.
For which fin boxes do you produce your fins?
We make our fins in Tuttle, Deep Tuttle and Power Bases. Per model you can specify what base you would like as long as the desired base is available for that certain fin.
Are the images of the items correct?
The images are a good representation of the products. Colours of images may deviate slightly from the items delivered. No rights can be derived from this.
